![]() ![]() (Doesn’t have to be XLR, could be 1/4" TRS).īut you don’t have the problem with other software. You should use a balanced line if you’re not doing so already. I now have Yamaha powered monitors, but I use the XLR connection on them. It could be even a relationship thru the AC circuit). Disconnect other inputs to see if it helps. (idea #2: It could be an interaction between multiple audio inputs going into the mixer. ![]() I believe the audio interface, the amp, and the computer soundcard had somehow shared a ground that they couldn’t agree on, despite all being on the same AC circuit. I discovered that it went away when I disconnected the inactive signal. I was using a home stereo system.) Regardless of which signal was active, there was moderately high pitched noise (more of a white noise than a sawtooth). So I was running 2 stereo audio signals to my amp, with one of them selected at any time. (idea #1: It could be some interaction between the DAW and other software somehow running in the background that makes just a whisper of noise, so maybe silence other software sound sources.) This was any sound generated outside of Cubase never makes it to the audio interface. I was running Cubase thru my audio interface, and system sounds thru the regular sound card. It’s unlikely to be the same problem, but for what it’s worth: Has anyone got any ideas as to how I can eliminate this problem, without having to do without the USB interface between my computer and Yamaha mixer entirely? Someone somewhere mentioned something about USB frames being in 1ms periods, so I’m speculating that this is somehow related to feedback over the USB interface between the PC and the Yamaha MW10c (again, this only happens with Cubase not other software). It is exactly 1kHz (I’ve tested it with a tuner) and it sounds much like a saw tooth wave. It is also worth mentioning that the noise persists even without any audio inputs connected to my computer or mixer. It is independent of my (powered) speaker volumes or the stereo output volume on my Yamaha MW10c mixer (it’s still apparent when ALL volumes are -inf dB on both the mixer, speakers and Windows’ mixer), so it’s clearly nothing to do with noise/interference in any of the analogue components of my gear. The noise is not overly loud, but loud enough to be quite intrusive.Ĭuriously enough, it is significantly louder from my right speaker than from my left speaker.ĭisconnecting either of the two speakers does not change the level of it coming out of the other. My Yamaha MW10c mixer then sends the analogue stereo output via 1/4" line-level cables to my pair of Yamaha HS80M powered speakers.Īll of the above mentioned products/equipment I’ve purchased and registered. I’ve ensured that my computer has the latest Windows 10 compatible driver for this mixer installed on it. The PC is coupled to my Yamaha MW10c mixer via a direct USB connection. It DOESN’T happen with any other software that I use. It begins the moment I load up Cubase 7.5 and remains constant and persistent (except when I disable the sound driver in Cubase entirely) until I finally close Cubase 7.5. I also am hearing a constant high-pitch sound through my speakers. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |